Tronic TSW 150 A1 Bedienungsanleitung PDF herunterladen (Seite 39)

- 36 -

Low battery signal

• When the battery runs low (under 11 V) a conti-

nuous signal tone sounds to indicate that the bat-

tery needs to be charged. The operation

LED/Overload indicator

continues to light up

green.

• When the battery voltage drops below 10 V

the power inverter switches off and the operation

LED/Overload indicator

lights up red.

Charging the USB device

Attention!

Before connecting, check to ensure that the

power consumption of the USB device is not

higher than 500 mA. Further information is to

be found in the operating manual for your

USB device.

• Plug the USB connector of the USB device to the

USB port

of the voltage converter.

• If necessary, switch the USB device on.

Note:

The 220-240 V power socket

and the USB

connector

can be used simultaneously.

Exchanging the Cable Fuse

Risk of potentially fatal electrical

shock:

Disconnect the power inverter from the power

source before changing the fuse. Also remove

any devices connected to the power inverter.

Replace the fuse with an equivalent type in regard

to the specified technical data and with the same

shut-off characteristics.

Before switching on and resuming operations with

the voltage converter, establish the cause for the

triggering of the fuse.

To exchange the fuse, proceed as follows:

• Loosen the screw on the fuse holder

using a

Phillips screwdriver.

• Open the cover of the fuse holder

and pull

the flat car fuse from the holder.

• Install a new 20 A flat car-type fuse (supplied)

into the two connectors and replace the cover

onto the fuse holder

• Firmly screw the screw on the fuse holder

back in.

IB_79839_TSW150A1_GB_LB_CH.qxd 21.11.2012 15:09 Uhr Seite 36

1 2 ... 34 35 36 37 38 39 40 41 42 43

Kommentare zu diesen Handbüchern

Keine Kommentare

Tronic TSW 150 A1 Bedienungsanleitung Seite 39

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromversorger Tronic TSW 150 A1